Why is a rear hub motor better than a front hub motor?
We have chosen a 220W rear hub motor as we find that it gives much better acceleration than larger 250W front hub motors. This is because we can use maximum motor torque without worrying about wheel slip.
To explain more, folding bikes tend to have a more rear heavy weight distribution than non-folders (this is to allow for a compact fold when the rear part of the bike swings under). This gives relatively little weight over the front wheel. This issue is exacerbated when going uphill, since the weight distribution shifts even more rearwards and the demand for torque from the motor increases. With front hub motor ebikes this can be accounted for by capping the max torque from the motor, so as to minimise the likelihood of slipping, but this is at the cost of reduced assistance. With the FLIT-16, the max torque doesn’t have to be capped, so you get the maximum amount of boost from the motor.
Related Articles
Who makes the rear hub motor?
The motor used on the FLIT-16 is manufactured by Bafang. The motor used in the M2 is made by MiVice. We chose MiVice for the M2 as they have a good reputation within the ebike industry, the high quality and the natural feeling ride that the motor ...
How does the motor work?
The bike senses how hard you are pedalling, and then amplifies your pedalling effort with power from the rear hub motor. Placing the motor in the rear wheel allows for greater acceleration and a natural feeling ride. It’s a 220W rear hub motor, ...
How to install front and rear mudguards
TOOLS NEEDED 4mm allen key 10mm socket or spanner DIAGRAM INSTRUCTIONS - Please find attached to this article FRONT MUDGUARD INSTALLATION Place a 4mm allen key into the screw holding the front light, and a 10mm socket or spanner onto the dome nut on ...
How to use the folding front and rear mudguards on a FLIT-16
UNFOLDING To use your rear mudguard, unroll it, with your index finger, to the full extent. Then, bend the tail downwards to lock it into position. Repeat the process to unfold your front mudguard. FOLDING To roll again, bend the tail upwards and ...
How to remove and re-install the rear wheel
TOOLS NEEDED Something soft for the floor, to rest your bike onto Wire cutters or pliers Either a 15mm deep socket, 15mm pedal spanner OR an adjustable spanner REMOVAL INSTRUCTIONS First, remove the chain. The easiest way is to push the chain ...