Accessories
Can you recommend a carrying handle for my FLIT bike?
One of our customers has recommended this Mottez carrying handle. It has adjustable velcro straps that fit onto the top tube of the bike. You just need to make sure that the straps go underneath any cables on the FLIT-16, not over the top of them (so ...
How to install front and rear mudguards
TOOLS NEEDED 4mm allen key 10mm socket or spanner DIAGRAM INSTRUCTIONS - Please find attached to this article FRONT MUDGUARD INSTALLATION Place a 4mm allen key into the screw holding the front light, and a 10mm socket or spanner onto the dome nut on ...
How to install a kickstand
TOOLS NEEDED Ratchet with deep 15mm socket, or 15mm bike spanner INSTRUCTIONS The kickstand should be installed on the non-drive side (the side without the chain). First, you’ll need to remove the wheel nut using a deep 15mm socket or a 15mm bike ...
Are mudguards available with the FLIT-16?
Yes. You can add mudguards when ordering your ebike through the bike builder. If you’ve already ordered your ebike, you order mudguards at any time via the Accessories page.
How to swap the saddle
TOOLS YOU’LL NEED 4mm Allen key INSTRUCTIONS The FLIT-16 is compatible with any standard saddle. To remove the saddle, first, undo the seat post quick release and remove the seat post from your bike. Place the saddle upside down on a table so that ...
How to fit the Klickfix Handlebar Adapter
FITTING THE ADAPTER The Klickfix adapter can be fitted onto the handlebar stem, or steerer tube – depending on which position you’d like your bag to be in. Klickfix instructions on how to fit the adapter can also be found here. TOOLS REQUIRED: 1 x ...
How to fit the Frost + Sekers Quicklock Saddle Mount
TOOLS YOU’LL NEED 4mm Allen key INSTRUCTIONS First, undo the seat post quick release and remove the seat post from your bike. Place the saddle upside down on a table so that you can easily access the bolts on the saddle rails. Undo both bolts using a ...
How to fit your Foldylock Compact bike lock
HOW TO FIT YOUR FOLDYLOCK: First, remove the lock from the holder. Undo the velcro straps, then place the holder between the arms connecting the front of the bike to the top tube, as shown in the video above. Thread the velcro straps to secure the ...