Why do I feel less assistance when the battery is less than 20%?

Why do I feel less assistance when the battery is less than 20%?

When the battery is <20% charged, it goes into “low power mode”, which means that you’ll feel slightly less assistance from the motor.

The reason for this is that lithium ion batteries have a limit as to how much power can be drawn from the battery in a low state.

For Li batteries, this usually kicks in around 20% – which is why you feel reduced power at this level.

This is completely normal, so is nothing to worry about.

We recommend that you keep your battery within an optimum range of 30-70% charged in order to maximise it’s lifespan and performance.

If you are concerned that your battery isn’t performing as well as it should, please contact us, we can run a diagnostic to check your battery health.

    • Related Articles

    • How should I store my battery?

      The lifespan of the battery can be extended by following the tips below: If you’re not using your battery for a long period of time (e.g. for a month or more) you can put the battery in hibernation mode by holding down the power button. In this mode, ...

    • How to set the assistance level

      SETTING THE ASSISTANCE LEVEL To use your ebike, first turn it on by holding down the power button which is located on the handlebar display. Once activated, you can use the plus (+) and minus (-) buttons on the keypad to alter the level of assistance ...

    • How to remove and insert the battery

      To remove the battery First, undo the seat post quick release and remove the seat post from the bike. Then, grasp the black rear light holder and slide the battery out of the top tube. To insert the battery To insert the battery, align the charging ...

    • Why doesn't my battery charge to 100%?

      The figure on the display is not terribly accurate (probably +/-5%) – anything above 90% would be considered typical. When your battery starts losing charge after many cycles, that maximum number (97% in this case) will start to decrease, but it ...

    • The clamp handles feel difficult to turn, what should I do?

      To tighten the clamp handles, you should tighten as far as you can with one finger, then add a quarter turn with two. This prevents the clamp being over-tightened, which can cause damage. If you notice that the clamp handles feel more difficult to ...