How to fold and unfold the pedals

How to fold and unfold the pedals



FOLDING THE PEDALS


To fold, place your thumb on the pedal arm and fingers on the pedal.

Squeeze, and then lift the pedal up.

You should always make sure that you fold the pedals before folding the bike.

​

UNFOLDING THE PEDALS


To unfold, spin the pedal to the top.

Place your fingers underneath the pedal, then pull firmly down with your palm until it clicks into place.


    • Related Articles

    • How to fold your FLIT-16

      ​ Step by step guide Stand by the chain. Fold both pedals by placing your thumb on the pedal arm (crank) and fingers on the pedal. Then squeeze and pull the pedal up. Spin the nearest pedal to the top  Twist the handlebars towards you  Step on the ...

    • How to unfold your FLIT-16

      Step by step guide Undo the seat post quick release and twist the saddle up to number 5. You can adjust this later if necessary. Tighten the quick release. Stand by the front wheel of the bike.  Lift the bike by the saddle, and raise the handlebars. ...

    • Can the pedals be replaced with SPDs (Shimano Pedaling Dynamics)?

      Yes. They just might stick out a little further than the standard pedals, which may get in the way when carrying the bike.

    • How to unbox your FLIT Bike

      Unboxing First, carefully open the box using a pen knife or scissors. Try not to damage it as you may need it for the future. Take out any accessories on the top layer of the box, then remove your seat post, manual and folding instructions, charging ...

    • How to install front and rear mudguards

      TOOLS NEEDED 4mm allen key 10mm socket or spanner DIAGRAM INSTRUCTIONS - Please find attached to this article FRONT MUDGUARD INSTALLATION Place a 4mm allen key into the screw holding the front light, and a 10mm socket or spanner onto the dome nut on ...